Not sure if other people have run into this issue…
If you lose your mining boosts while in an asteroid belt, and are the standard 20-25 km out at the warp point, the script cannot currently detect a change in supported mining laser range, and therefore, will remain out of laser distance constantly trying to cycle the lasers on the target. As soon as boosts are restored the script will start correctly mining.
Would there be any bad side-effects if I added a ModuleMeasureAllTooltip() within the InBeltMineStep() function if I only ran it periodically?
Thanks!
Not sure if other people have run into this issue…
If you lose your mining boosts while in an asteroid belt, and are the standard 20-25 km out at the warp point, the script cannot currently detect a change in supported mining laser range, and therefore, will remain out of laser distance constantly trying to cycle the lasers on the target. As soon as boosts are restored the script will start correctly mining.
Without wrote something to address this issue: http://forum.botlab.org/thread/mining-script-of-without/
Les modules seront remesurés après chaque stop (pour pas redémarer le bot lorsqu’on perd des bonus par exemple)