I don’t know if this bot is in active development anymore, but I did like it enough to buy a subscription. There are some problems and requests that I’d like to have to make it better. I feel like these can all be implemented in the configuration settings window before starting the bots.
Minimum mining laser distance; by default, it approaches the rocks and finally turns on the lasers. I wish I could set it to only approach to my desired distance, and then stop and activate lasers.
Problem with laser activation; while using the Modulated Strip Miner II, the bot will click the activate button multiple times turning the lasers on and off repeatedly until finally leaving it on. I don’t know why, and I haven’t tested other laser modules. But this wastes 30 seconds each time a new rock is targeted. This also uses up all your capacitor battery life causing a continuous looping problem. Would like to optimize the bot to only push the button once to activate the lasers.
Asteroid prioritization; would like to set a priority for rocks to be mined at a given site. That way the bot selects the expensive rocks first, then moves on. I can already edit the Overview to only show the good rocks, so that’s fine there.
Otherwise, it still works great so far. I can upload my session also.
Thank you
That sounds like there is too long of a delay between clicking on the module button and the appearance of the indication showing that the module is already active. You can mitigate that by increasing the delay between bot steps, by adding this setting in your bot prompt before starting the session: